Denis Watkins Posted November 1, 2022 Share Posted November 1, 2022 911, With the PROP OFF link up you lipo again The BEEP signifies High Throttle See if the trim is down below centre If the Beep continues, the reverse the throttle on the Tx all with Prop off Quote Link to comment Share on other sites More sharing options...
911hillclimber Posted November 1, 2022 Author Share Posted November 1, 2022 Excellent! will try tomorrow. Quote Link to comment Share on other sites More sharing options...
GrumpyGnome Posted November 2, 2022 Share Posted November 2, 2022 I have a few ESCs that by design have the capacitors exposed - they work fine so don't bin it just yet. Quote Link to comment Share on other sites More sharing options...
911hillclimber Posted November 2, 2022 Author Share Posted November 2, 2022 Thank you! All seems sorted now, it was 'operator error' ( of course). I had the ex connected to the esc in the Battery position, not throttle position... with all other controls disconnected, just the esc lead to the Throttle pin 1, followed the advice on here and all is correct. Throttle all works, and have all the control surfaces all responding correctly by orientation. Juat have to set the movement ranges now as all surfaces move at least 45 degrees which would make for a wild flight.. As ever, thank you to all and your patience in helping a novice get sorted. Really like this plane. Quote Link to comment Share on other sites More sharing options...
BackinBlack Posted November 2, 2022 Share Posted November 2, 2022 Glad you got it sorted, hope the maiden goes well. Quote Link to comment Share on other sites More sharing options...
911hillclimber Posted November 2, 2022 Author Share Posted November 2, 2022 Doubt I will get it into the air this year, but taking it to the field tomorrow for my buddy man to look over and advise on surface movement. I am about to set the ele/ alien to the same ish movement as the Kingfisher making an assessment of the Kingfish surface area v this SU 26m's areas. Going for about 5 to 8 degrees both ways, hope that will be about right for my skill base. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.