Andy C Posted June 27, 2023 Share Posted June 27, 2023 I have so far managed to work things out as I have gone along on my new journey into frsky. But my first real struggle is setting up the throttle on an ic engine. I want to end up with a stick that moves from idle at fully back position to full throttle at fully forwards position and then a switch that when activated cuts the engine. At moment I just have a setup that has throttle control moving the engine carb from fully closed to fully open. where do I go next please? thanks all. Quote Link to comment Share on other sites More sharing options...
PDB Posted June 27, 2023 Share Posted June 27, 2023 (edited) https://youtube.com/watch?v=tzWV1XZz7zI Edited June 27, 2023 by PDB Quote Link to comment Share on other sites More sharing options...
Philip Lewis 3 Posted June 27, 2023 Share Posted June 27, 2023 Its also covered I think a bit better in the manual pages 60 to 62 (which I've attached) and is one of the "canned" mixes which I would think would be suitable for an IC motor although maybe a bit simplistic for some electric set ups. ETHOS_Throttle Cut.pdf 1 Quote Link to comment Share on other sites More sharing options...
Andy C Posted June 28, 2023 Author Share Posted June 28, 2023 Thanks guys. Managed to find the Low Position trim which is what I needed 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.