cymaz Posted March 10 Author Share Posted March 10 1 hour ago, Outrunner said: I've never seen a cow in a workshop before 😄 Ermintrude ! Quote Link to comment Share on other sites More sharing options...
cymaz Posted March 11 Author Share Posted March 11 On 05/02/2024 at 09:41, Engine Doctor said: Hope your painter uses a little plasticiser in the paint. 2k is good but can crack on flexible substrates unless plasticiser is used especially in vold weather. Just ouf of interest could you weigh the parts before and after painting ? Added 150g to the wing and 100g to the fuselage  1 Quote Link to comment Share on other sites More sharing options...
cymaz Posted March 12 Author Share Posted March 12 Well, it’s done. There was some paint pull off the nylon in a couple of places but they’re very very small. They touched up ok.   2 Quote Link to comment Share on other sites More sharing options...
Geoff S Posted March 12 Share Posted March 12 Looks a treat, Cymaz. You will have to be careful how you park it in the pits, though, otherwise the XL logo won't be the right way up 🙂 Quote Link to comment Share on other sites More sharing options...
cymaz Posted March 12 Author Share Posted March 12 I’ll bear that in mind ! 🤗 Quote Link to comment Share on other sites More sharing options...
cymaz Posted March 24 Author Share Posted March 24 Had about 10 short trimming flights this afternoon. It’s the first time I’ve been out since early January!! The flaps worked very well at 90*, and needed only 3-4mm of down elevator to compensate. The plane will need some weight on the port wing but that will be done this week as it’s due to pour down all this week....again   7 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.